Fujitsu ETERNUS DX200F Configuration Manual page 30

Chapter 3 Checking the Configuration Environment
3.4 LAN Connection Preparation for Operation Management
*1: Only the following functions are available:
• Checking the ETERNUS DX status
• Switching the Master CM
*2: May use either the MNT port or RMT port.
*3: Modifiable
For details on the port numbers for the ETERNUS SF Software, refer to the manual of each Storage Foundation
Software ETERNUS SF.
■
Communication Modes
The default LAN operation mode is "Auto Negotiation" which allows the ETERNUS DX to automatically recog-
nize 1000Base-T/100Base-TX/10Base-T and Full/Half-Duplex connections. However, some devices may re-
quire that a fixed communication mode be set.
FUJITSU Storage ETERNUS DX200F All Flash Array Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
30
P3AM-8462-01ENZ0