Power Source Options; Factory Reset Button; Led Indicators And Run Dark Mode - Meraki MR62 Setup Manual

2.4 Power Source Options

The MR66 access point can be powered using either a third-party 802.3af PoE switch or the Meraki
802.3af PoE injector (sold separately).

2.5 Factory Reset Button

The Factory Reset Button restores the MR66 to its original factory settings by deleting all configuration
information stored on the unit.

2.6 LED Indicators and Run Dark Mode

Your MR66 is equipped with a series of LED lights on the front of the unit to convey information about
system functionality and performance.
Signal Strength
One Light:
Four Lights:
Moving Lights:
Flashing Lights:
Radio Power
Off:
Solid Orange:
Solid Green:
Flashing Orange:
Flashing Green:
Ethernet
Off:
On:
Flashing:
The MR66 may be operated in "Run Dark" mode for additional security and to reduce the visibility of the access
point. In this mode, the LEDs will not be illuminated. This mode may be enabled through Meraki Dashboard.
9
Fair
Strongest
Searching for Signal
Error state. May indicate bad gateway or other routing fault
MR66 is off
MR66 is booting or trying to find a path to the internet
MR66 is fully operational and connected to the network
Firmware is upgrading
Error state. May indicate bad gateway or other routing fault
No active network connection at the Ethernet port
Active network connection at the Ethernet port
Error state. May indicate bad gateway or other routing fault