The Speed Test; The Software Revision Level Test - Stairmaster STEPMILL 7000 PT Assembly Instructions Manual

the function keypad will light an LED within the outline on the display that
corresponds to that button's position on the console.
3. Firmly press each button. If the LED corresponding to the button you
pushed does not light up, the keypad is bad and the console should be
replaced.
4. Press [CLEAR] to test the LED and then end the test.

THE SPEED TEST

Use this test to verify the electronic speed control routines of the console. You
will need to briefly exercise on the machine for this test.
1. Press [3] to start the test.
2. The console will be set at a certain speed. The alternator speed, in RPM,
is displayed on the text bar as "Target" and a single column of lights will
light up on the display.
3. Begin exercising. As the stairs rotate, the text bar will alternately show the
actual RPM and the target RPM.
4. Press [CLEAR] to return to the DIAGNOSTIC mode.

THE SOFTWARE REVISION LEVEL TEST

This test allows you to check the version number of the software installed in the
console.
1. Press [4] to start the test.
2. The software version number will be scrolled across the text bar. The
console will automatically return to the DIAGNOSTIC mode.
3. Contact the Customer Service Department for the most current software
revision update.
CONSOLE DIAGNOSTIC TESTS
Page 31