Troubleshooting - ICE AIR Console Water Source Heat Pump Operating Manual

operating & maintenance manual – console water source heat pump (wshp)
COMPRESSOR
Annual check should be performed to detect
potential problems.
•
Amperage draw should not exceed normal
full load amps (FLA) (consult nameplate for
information.)
HEAT EXCHANGER
Water coil maintenance is not required. If the
unit installation is located in a system with water
problem history it is best to establish a periodic
maintenance program. It is the building's
responsibility to maintain a water system that
should provide your unit with treated and filtered
water to keep water flowing freely through your
equipment.
Generally if the water flow exceeds 3 gpm per ton
the water velocities should keep your coil free of
scaling and debris that could lead to coil erosion
and fouling.
general unit inSpection: Visually inspect unit
at least once a month. Pay special attention to hose
assemblies and connections. Repair any leaks and
replace deteriorated hose immediately to avoid
potential costly damage to your property due to
component failure.

trouBleSHooting

1. If unit is not operating, conduct the following checks:
•
If a flashing "A" appears on the display,
contact a trained technician.
•
Check the electrical connections.
•
Check the voltage and current against the
electrical specifications on the unit nameplate.
•
Look for wiring errors. Check for loose
screw connections in both line and low
voltage terminals.
•
Check the water supply piping for proper
water connection.
• Check for dirty filters.
•
Check indoor fan for proper operation.
•
Check that unit did not cycle off on thermostat.
•
Check for fault codes on the control board
consult the trouble shooting guide.
2. If checks above fail to reveal operating problem
and the unit still does not operate after reset,
contact a trained service technician to conduct
full unit diagnostics and to repair the equipment.
10