ICE AIR Vertical Stack Water Source Heat Pump Operating & Maintenance Manual

Advertisement

Quick Links

OPERATING & MAINTENANCE MANUAL
Vertical Stack Water Source Heat Pump (VWSHP)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Vertical Stack Water Source Heat Pump and is the answer not in the manual?

Questions and answers

Summary of Contents for ICE AIR Vertical Stack Water Source Heat Pump

  • Page 1 OPERATING & MAINTENANCE MANUAL Vertical Stack Water Source Heat Pump (VWSHP)
  • Page 2: Safety Warnings

    OPERATING & MAINTENANCE MANUAL – VERTICAL STACK WATER SOURCE HEAT PUMP (VWSHP) WELCOME Congratulations on your selection of ICE AIR Water Source SAFETY WARNINGS: Heat Pumps (WSHPs) for your comfort conditioning requirements. WSHP units are combination cooling and heating units which •...
  • Page 3 – severe injury and death can occur from electric shock, moving parts, and other hazards. • Your ICE AIR units must each be wired on an individual, dedicated electrical circuit with the correct voltage and proper amperage (capacity) to match the unit nameplate requirements.
  • Page 4: Electrical Data

    OPERATING & MAINTENANCE MANUAL – VERTICAL STACK WATER SOURCE HEAT PUMP (VWSHP) ELECTRICAL DATA CONTROLS • Ensure that available power is the same voltage and phase as ICE AIR Vertical Stack WSHP units are controlled by a state-of- indicated on the unit serial plate. Line and voltage wiring must...
  • Page 5: Operation

    • Turning the unit OFF LOCKOUT SAFETY • Resetting the Temperature Control to a Warmer All Ice Air WSHP units have its own lockout circuit to shut down the position compressor during an abnormal condition. During unit operation the • Switching from Cooling mode to any other mode compressor will be automatically turned off due to one of these safety conditions.
  • Page 6: Maintenance And Service

    OPERATING & MAINTENANCE MANUAL – VERTICAL STACK WATER SOURCE HEAT PUMP (VWSHP) MAINTENANCE & SERVICE CAUTION: to prevent injury or death due to electrical shock or contact with moving part, turn off the disconnect switch before servicing this unit. IMPORTANT NOTE: It is not the intent of this maintenance manual to correct any installation deficiencies. If you have any doubt about the proper initial installation (or reinstallation after servicing) of your WSHP unit(s)- noisy or inefficient unit operation,frayed or damaged electrical connections, improper unit appearance, etc.
  • Page 7 OPERATING & MAINTENANCE MANUAL – VERTICAL STACK WATER SOURCE HEAT PUMP (VWSHP) Compressor: Evaporator Coil: Annual check should be performed to detect potential Check the coil for cleanliness and uniformity of fins. If the coil problems. is dirty, vacuum clean with a soft brush attachment. This is the • Amperage draw should not exceed normal full load amps indicated...
  • Page 8 High Water Temperature Protection FLASH Over/Under Voltage Protection Condensate Overflow Protection Low Water Temperature Protection FLASH 80 Hartford Avenue, Mount Vernon, NY 10553 | Tel: 877-ICE-AIR-1 (877-423-2471) | Fax: 914-668-5643 | email: service@ice-air.com www.ice-air.com | © 2013 by ICE AIR, LLC...

Table of Contents