Table of Contents
Advertisement
SAMSUNG DCS 70
INSTALLATION MANUAL
Chapter Three : Installation Of The DCS 70
UNPACKING AND INSPECTION
After unpacking the KSU, inspect the unit for signs of physical damage. KSUs with any sign
of physical damage should be returned to the supplier for replacement.
Check to see that the KSU carton includes the following items:
• DCS 70 Key Service Unit (KSU) which includes:
• Memory card
• 20W Ringer
• Paper Mounting Template
• Power cable
• Wall-mount kit consisting of cable ties, four screws, spare fuses and Battery Backup cable
The EXPANSION Cabinet is provided as an add-on option. If provided, check that the
expansion cabinet carton includes the following:
• Expansion Cabinet
• Mounting screws and cable tie.
KEY SERVICE UNIT INSTALLATION
The Key Service Unit (KSU) must be wall-mounted in a vertical position.
The KSU has 4 key holes on the sides of the KSU for wall mounting. See Figure 3.1
Use the mounting template supplied to position the screw holes correctly. Insert the screws
but do not tighten.
Position the KSU on to all screws at the same time and then lower the KSU so that it is
secured in the Keyholes. Tighten all screws to complete the installation.
(see Figure 3-1).
The KSU should be mounted on a section of the wall capable of holding the weight of the
system (approximately 12 Kg fully loaded including Expansion Cabinet) and cables. For
example close to a stud or noggin.
EXPANSION CABINET INSTALLATION
The DCS 70 system is shipped from the factory equipped with the 008 motherboard, Memory
card power supply and ringer.
The expansion metal cabinet is an optional cabinet that provides 3 additional universal
expansion slots and a dedicated expansion slot for future features such as an integrated Voice
mail card, PRI card and E&M tie line card. The expansion cabinet is supplied in separate
packaging and is installed as described below.
1.
The Expansion Cabinet has two mounting lugs on the left hand side of the cabinet
which fit into slots on the KSU. In addition the cabinet has 2 key holes on the right
hand side of the cabinet to complete the mounting. (see Fig 3-3)
Page 3-1
th
10
January, 2000
Advertisement
Table of Contents
