Replacing The Secondary Hard Disk Drive - Lenovo ThinkCentre 7515 Maintenance Manual

Hide thumbs Also See for ThinkCentre 7515:
Table of Contents

Advertisement

10. Align the drive cage pivot pin with the slot 1 in the upper drive cage and
11. Connect the signal cable and the power cable to the rear of the new hard disk
12. Press down on the metal latch 2 and pivot the drive cage into place, and
Figure 22. Installing the primary hard disk drive with the hard disk drive cage
13. Go to "Completing the FRU replacement" on page 120.

Replacing the secondary hard disk drive

Note: Depending on your model type, your computer might come with a
This section provides instructions on how to replace the secondary hard disk drive.
slide the hard disk drive cage into the chassis.
drive.
then slide it forward until it snaps into position.
Note: There are two arrows, one on the upper drive cage and one on the hard
disk drive cage. The arrows are aligned when the hard disk drive is in
the proper position.
Attention
Do not open your computer or attempt any repair before reading and understanding the
"Important safety information" in the ThinkCentre Safety and Warranty Guide that came with
your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
secondary hard disk drive bay for installing or replacing a secondary hard
disk drive.
Chapter 8. Replacing FRUs - Tamdhu computers
107

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents