Replacing The Microprocessor - Lenovo ThinkCentre 7515 Maintenance Manual

10. Go to "Completing the FRU replacement" on page 120.

Replacing the microprocessor

This section provides instructions on how to replace the microprocessor.
CAUTION:
The heat sink and microprocessor might be very hot. Turn off the computer and
wait three to five minutes to let the computer cool before removing the
computer cover.
To replace the microprocessor:
100
Hardware Maintenance Manual
8. Alternate tightening each screw a small and equal amount until the heat sink
and fan assembly is secured to the system board. Do not over-tighten the
screws.
9. Connect the new heat sink and fan assembly cable to the microprocessor fan
connector on the system board.
Attention
Do not open your computer or attempt any repair before reading and understanding the
"Important safety information" in the ThinkCentre Safety and Warranty Guide that came with
your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
1. Remove the computer cover. See "Removing the computer cover" on page 86.
2. Lay the computer on its side for easier access to the system board.
3. Remove any parts or cables that may prevent your access to the system board.
4. Disconnect the heat sink and fan assembly cable from the microprocessor fan
connector on the system board. See "Locating parts on the system board" on
page 89.
5. Remove the heat sink and fan assembly. See "Replacing the heat sink and fan
assembly" on page 98.
6. Place the heat sink and fan assembly on its side so that the thermal grease
does not come in contact with anything.