Toro Groundsmaster 4000-D Service Manual page 34

following electrical components:
A. The temperature sender and alternator (Fig 10).
B. The engine run solenoid and fuel pump (Fig. 12).
C. The high temperature shutdown switch and glow
plug (Fig. 13).
D. Battery, frame, and wire harness ground to the
engine block (Fig. 14).
E. The starter (Fig. 14) and low oil pressure switch
(near starter).
14.Install air cleaner assembly to the engine (see Air
Cleaner Installation).
15.Install exhaust system to machine (see Muffler
Installation).
16.Connect coolant hoses to the radiator. Make sure ra-
diator drain is shut. Fill radiator and reservoir with cool-
ant (see Operator's Manual).
Kubota Diesel Engine (Rev. B)
17.Check position of wires, fuel lines, hydraulic hoses,
and cables for proper clearance with rotating, high tem-
perature, and moving components.
18.Position battery to machine. Connect positive bat-
tery cable first and then negative battery cable. Secure
battery to machine with strap and cover.
19.Check and adjust engine oil as needed (see Opera-
tor's Manual).
20.Check and adjust hydraulic oil as needed (see Oper-
ator's Manual).
21.Bleed fuel system (see Operator's Manual).
22.Operate hydraulic controls to properly fill hydraulic
system (see Charge Hydraulic System in Chapter 4 −
Hydraulic Systems).
Page 3 − 18 Groundsmaster 4000−D