Service Indicator Zero Reset; Engine Oil Level Indicator - CITROËN C5 Owner's Handbook Manual

Hide thumbs Also See for C5:
Table of Contents

Advertisement

Service indicator
I
zero reset
After each service, the service indi-
cator must be reset to zero.
The procedure for resetting to zero
is as follows:
switch off the ignition,
press and hold the trip distance
recorder zero reset button,
switch on the ignition; the dis-
tance recorder display begins a
countdown,
when the display indicates "=0" ,
release the button; the spanner
disappears.
Following this operation, if you wish
to disconnect the battery, lock the
vehicle and wait at least fi ve minutes
for the zero reset to be taken into ac-
count.
40
M O N I T O R I N G

Engine oil level indicator

System which informs the driver
whether the engine oil level is cor-
rect or not.
This information is indicated for a
few seconds when the ignition is
switched on, after the service infor-
mation.
The level read will only be correct if
the vehicle is on level ground and
the engine has been off for more
than 30 minutes.
Oil level correct
Oil level incorrect
This is indicated by the message
"Oil level incorrect".
If the low oil level is confi rmed by a
check using the dipstick, it is essen-
tial that the level is topped up to pre-
vent damage to the engine.
Oil level gauge problem
This is indicated by the message "Oil
level measurement invalid". Contact
a CITROËN dealer or a qualifi ed
workshop.

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the C5 and is the answer not in the manual?

Questions and answers

Vic Carrington-Porter
February 15, 2025

HOW DO I REMOVE THE HEADLIGHT WASHER ON MY C5

1 comments:
Mr. Anderson
February 15, 2025

To remove the headlight washer on a CITROËN C5:

1. Extend the washer nozzle by pulling it forward.
2. Use a blunt flat blade to carefully pry the cover forward about 20mm.
3. Wrap a loop of cord around the main nozzle unit to hold it in place.
4. Unclip the cover from the bottom, hinge it up, and lift it off.
5. Pull the nozzle forward again using fingers and secure it with a cord.
6. Once the cover is removed, proceed with detaching the washer mechanism as needed.

Be careful, as the clips are fragile.

This answer is automatically generated

Table of Contents

Save PDF