"Isofix" Mountings; In The Rear; Saloon; Tourer - CITROËN C5 Owner's Handbook Manual

Hide thumbs Also See for C5:
Table of Contents

Advertisement

"ISOFIX" MOUNTINGS

Your vehicle has been approved in
accordance with the new ISOFIX
regulation s .
The outer rear seats are fi tted with
regulation ISOFIX mountings.
C H I L D S A F E T Y

In the rear

Saloon

These are three rings for each outer
rear seat:
-
two lower rings A , located be-
tween the vehicle seat back and
cushion, indicated by a label,
-
an upper ring B , fi xed to the rear
shelf, concealed under a fl ap
with the logo TOP TETHER be-
hind the head restraint.

Tourer

-
two lower rings A , located be-
tween the vehicle seat back and
cushion, indicated by a label,
-
an upper ring C , fi xed to the
roof on the boot side, concealed
under a fl ap with the logo TOP
TETHER.
This ISOFIX mounting system pro-
vides fast, reliable and safe fi tting
of the child seat in your vehicle.
The ISOFIX child seats are fi tted
with two locks which are secured
easily on the two rings A , following
installation of the guides (supplied
with the seat).
Some also have an upper strap
which is attached to the ring B or C .
To attach this strap in the rear, re-
move the vehicle seat's head re-
straint and stow it. Lift the cover on
the rear shelf (Saloon) or the roof
(Tourer). Then fi x the hook on the
ring B or C and tighten the upper
strap.
The incorrect installation of a child
seat in a vehicle compromises the
child's protection in the event of an
accident.
For
information
regarding
ISOFIX child seats which can be
installed in your vehicle, consult
the table of positions for fi tting
ISOFIX child seats.
VII
the
109

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the C5 and is the answer not in the manual?

Questions and answers

Vic Carrington-Porter
February 15, 2025

HOW DO I REMOVE THE HEADLIGHT WASHER ON MY C5

1 comments:
Mr. Anderson
February 15, 2025

To remove the headlight washer on a CITROËN C5:

1. Extend the washer nozzle by pulling it forward.
2. Use a blunt flat blade to carefully pry the cover forward about 20mm.
3. Wrap a loop of cord around the main nozzle unit to hold it in place.
4. Unclip the cover from the bottom, hinge it up, and lift it off.
5. Pull the nozzle forward again using fingers and secure it with a cord.
6. Once the cover is removed, proceed with detaching the washer mechanism as needed.

Be careful, as the clips are fragile.

This answer is automatically generated

Table of Contents

Save PDF