JVC MX-G50 Service Manual page 12

MX-G50/MX-G56
<CD changer unit>
Prior to performing the following procedure, remove
the CD changer unit.
Removing the CD tray (See Fig.25 to 27)
1. Turn the black loading pulley gear on the under side
of the CD changer unit in the direction of the arrow
and draw the CD tray toward the front until it stops.
2. Disconnect the card wire from connector CW103 of
the CD servo board on the upper side of the CD
changer unit.
3. Push down the two tray stoppers marked g and pull
out the CD tray.
Reinstall the CD tray (See Fig.28 to 29)
1. Align the gear-cam with the gear-tray as shown
fig.27, then mount the CD tray.
2. When assembling the CD tray, take extreme care not
engage with gear - synchro.
Gear-cam
Gear-convert
Gear-convert Gear-tray
1-12
Gear-tray
Gear-cam
timing point
Fig.28
Loading pulley gear
CD tray
CD tray
g
(Tray stopper)
Gear-tray
CD tray
CD tray
Fig.25
Fig.26
g (Tray stopper)
CD servo board
CW103
Fig.27
Gear-synchro
Fig.29