JVC MX-G50 Service Manual page 11

<Front panel assembly>
Prior to performing the following procedure, remove
the metal cover, the CD changer unit and the front
panel assembly.
Removing the power / CD switch board
1. Disconnect the card wire from connector UCW1 of
the power / CD switch board.
2. Remove the five screws T attaching the power / CD
switch board and release the tab e outward.
Removing the FL display & system
control board
1. Disconnect the card wire from the connector UCW3,
UCW4,UCW5 and UCW6 on the FL & system control
board.
2. Remove the five screws U attaching the FL & system
board.
3. Disconnect the card wire from the connector UCW2
on the FL & system control board.
Removing the headphone board
Prior to performing the following procedure remove
the FLdisplay & system control board.
1. You can pull out the headphone board.
Removing the front board (See Fig.24)
Prior to performing the following procedure, remove
the FL display & system control board.
1. Pull out the volume knob, subwoofer knob and sound
mode nob from front side.
2. Remove the ten screws V attaching the front board
and release the two tabs f out ward.
Removing the
assembly (See Fig.24)
1. Disconnect the card wire x from the mechanism
board on the cassette mechanism assembly.
2. Remove the six screws W attaching the cassette
mechanism assembly.
(See Fig.22)
(See Fig.22 and 23)
(See Fig.24)
cassette mechanism
Power / CD switch board
UCW2
UCW3
UCW4
Fig.22
Fig.23
Front board
f
V
Card wire x
Cassette mechanism assembly
Fig.24
MX-G50/MX-G56
Tab e
T
U
FLdiplay & system
control board
U
UCW5
UCW6
Sound mode knob
Subwoofer knob
Volume knob
V
Headphone
board
V
W
1-11