Related Manuals for Seagate ST500LM021
Summary of Contents for Seagate ST500LM021
- Page 1 Product Manual Seagate Laptop Thin HDD SATA ® 7200 RPM formerly Momentus Thin SATA Standard models Self-Encryption models ST500LM021 ST500LM023 ST320LM010 SED FIPS 140-2 models ST500LM024 Gen 3.0 100737930 Rev. E October 2014...
- Page 2 Publication number: 100737930, Rev. E October 2014 Seagate, Seagate Technology and the Wave logo are registered trademarks of Seagate Technology LLC in the United States and/or other countries. Momentus and SeaTools are either trademarks or registered trademarks of Seagate Technology LLC or one of its affiliated companies in the United States and/or other countries.
-
Page 3: Table Of Contents
Seagate® Technology Support Services ........ - Page 4 S.M.A.R.T. commands ..........32 Seagate Laptop Thin HDD Product Manual, Rev. E...
- Page 5 Example of FIPS tamper evidence labels........21 Seagate Laptop Thin HDD Product Manual, Rev. E...
-
Page 6: Seagate® Technology Support Services
Authorized Service Centers For information regarding Warranty Support, visit: http://www.seagate.com/support/warranty-and-replacements/ For information regarding data recovery services, visit: http://www.seagate.com/services-software/data-recovery-services/ For Seagate OEM and Distribution partner portal, visit: http://www.seagate.com/partners/ For Seagate reseller portal, visit: http://www.seagate.com/partners/my-spp-dashboard/ Seagate Laptop Thin HDD Product Manual, Rev. E... -
Page 7: Introduction
Introduction ® This manual describes the functional, mechanical and interface specifications for the following Seagate Laptop Thin HDD model drives: Standard models Self-Encryption models SED FIPS 140-2 models ST500LM021 - 1KJ152 ST500LM023 - 1RR152 ST500LM024 - 1RS152 ST320LM010 - 1KJ15C... -
Page 8: Drive Specifications
40.0°C max (nonoperating) Altitude, operating –304.8 m to 3048 m (–1000 ft to 10,000+ ft) Altitude, nonoperating –304.8 m to 12,192 m (–1000 ft to 40,000+ ft) (below mean sea level, max) Seagate Laptop Thin HDD Product Manual, Rev. E... -
Page 9: Formatted Capacity
512 (logical) / 4096 (physical) 320GB model 320 GB 625,142,448 One GB equals one billion bytes when referring to hard drive capacity. Accessible capacity may vary depending on operating environment and formatting. Seagate Laptop Thin HDD Product Manual, Rev. E... -
Page 10: Lba Mode
69.85 +/- 0.25 mm (2.750 +/- 0.010 in) All models Length 100.35 +0.20 / -0.25 mm (3.951 +0.008 / -0.010 in) Typical weight <95 g (0.209 lb) Cache buffer 32 MB (32,384 KB) Seagate Laptop Thin HDD Product Manual, Rev. E... -
Page 11: Seek Time
Idle mode power is measured with the drive up to speed, with servo electronics active and with the heads in a random track location. Standby mode During standby mode, the drive accepts commands, but the drive is not spinning, and the servo and read/write electronics are in power-down mode. Seagate Laptop Thin HDD Product Manual, Rev. E... -
Page 12: Figure 1 Typical 5V Startup And Operation Current Profile
Standby power is measured at steady state (after 200ms from transition) 2.7.1.1 Typical current profiles The typical 5V startup and operation current profile is shown in Figure Figure 1 Typical 5V Startup and Operation Current Profile Seagate Laptop Thin HDD Product Manual, Rev. E... -
Page 13: Conducted Noise
If the standby timer reaches zero before any drive activity is required, the drive makes a transition to standby mode. In both Idle and standby mode, the drive accepts all commands and returns to active mode when disk access is necessary. Seagate Laptop Thin HDD Product Manual, Rev. E... -
Page 14: Environmental Specifications
The nonoperating shock level that the drive can experience without incurring physical damage or degradation in performance when subsequently put into operation is 1000 Gs based on a nonrepetitive half-sine shock pulse of 1 ms duration. Seagate Laptop Thin HDD Product Manual, Rev. E... -
Page 15: Vibration
Seagate follows the ECMA-74 standards for measurement and identification of PDTs. An exception to this process is the use of the absolute threshold of hearing. Seagate uses the lower limit for the threshold curve* to discern tone audibility and to compensate for the inaudible components of sound prior to computation of tone ratios according to Annex D of the ECMA-74 standards. -
Page 16: Electromagnetic Immunity
From this page, click on the “Check to see if the drive is under Warranty” link. The following are required to be provided: the drive serial number, model number (or part number) and country of purchase. The system will display the warranty information for the drive. Seagate Laptop Thin HDD Product Manual, Rev. E... -
Page 17: Agency Certification
55024. Drives are tested in representative end-user systems. Although CE-marked Seagate drives comply with the directives when used in the test systems, we cannot guarantee that all systems will comply with the directives. The drive is designed for operation inside a properly designed enclosure, with properly shielded I/O cable (if necessary) and terminators on all unused I/O ports. -
Page 18: Fcc Verification
Communications Commission verification or certification of the device is required. Seagate has tested this device in enclosures as described above to ensure that the total assembly (enclosure, disk drive, motherboard, power supply, etc.) does comply with the limits for a Class B computing device, pursuant to Subpart J, Part 15 of the FCC rules. Operation with noncertified assemblies is likely to result in interference to radio and television reception. -
Page 19: China Restriction Of Hazardous Substances (Rohs) Directive
Users should use caution exposing any electronic components to uncontrolled chemical pollutants and corrosive chemicals as electronic drive component reliability can be affected by the installation environment. The silver, copper, nickel and gold films used in Seagate products are especially sensitive to the presence of sulfide, chloride, and nitrate contaminants. Sulfur is found to be the most damaging. In addition, electronic components should never be exposed to condensing water on the surface of the printed circuit board assembly (PCBA) or exposed to an ambient relative humidity greater than 95%. -
Page 20: Configuring And Mounting The Drive
Figure Figure 2 Attaching SATA Cabling Signal connector Power connector Signal cable Power cable Each cable is keyed to ensure correct orientation. Laptop Thin HDD drives support latching SATA connectors. Seagate Laptop Thin HDD Product Manual, Rev. E... -
Page 21: Drive Mounting
6.81 ± .203 mm 2X .118 in 2.99 mm BOTH SIDES .230 in 3.567 in 5.84 mm 90.60 mm .551 in 13.99 mm .263 in 6.68 mm 2.430 in 61.72 mm .160 in 4.06 mm Seagate Laptop Thin HDD Product Manual, Rev. E... -
Page 22: About Fips
Figure 4 Example of FIPS tamper evidence labels. For reference only. May not represent actual drive. Note Seagate Laptop Thin HDD Product Manual, Rev. E... -
Page 23: About (Sed) Self-Encrypting Drives
The Trusted Computing Group (TCG) is an organization sponsored and operated by companies in the computer, storage and digital communications industry. Seagate's SED models comply with the standards published by the TCG. To use the security features in the drive, the host must be capable of constructing and issuing the following two SATA commands: ... -
Page 24: Random Number Generator (Rng)
In addition to providing a locking mechanism to prevent unwanted firmware download attempts, the drive also only accepts download files which have been cryptographically signed by the appropriate Seagate Design Center. Three conditions must be met before the drive will allow the download operation: 1. -
Page 25: Serial Ata (Sata) Interface
There are three power pins for each voltage. One pin from each voltage is used for pre-charge when installed in a blind-mate backplane configuration. All used voltage pins (V ) must be terminated. Seagate Laptop Thin HDD Product Manual, Rev. E... -
Page 26: Supported Ata Commands
Set Max Features register as defined to Password: the right. Lock: Unlock: Freeze Lock: Set Max Address Ext Set Multiple Mode S.M.A.R.T. Disable Operations B0h/D9h S.M.A.R.T. Enable/Disable Autosave B0h/D2h Seagate Laptop Thin HDD Product Manual, Rev. E... - Page 27 ATA-standard power-management commands Check Power Mode Idle Idle Immediate Sleep Standby Standby Immediate ATA-standard security commands Security Set Password Security Unlock Security Erase Prepare Security Erase Unit Security Freeze Lock Security Disable Password Seagate Laptop Thin HDD Product Manual, Rev. E...
-
Page 28: Identify Device Command
Number of current logical heads xxxx Number of current logical sectors per logical track xxxx 57–58 Current capacity in sectors xxxx Number of sectors transferred during a xxxx Read Multiple or Write Multiple command Seagate Laptop Thin HDD Product Manual, Rev. E... - Page 29 Hardware reset value (see description following this table) xxxx Auto acoustic management setting xxxx Stream Min. Request Size 0000 Streaming Transfer Time - DMA 0000 Streaming Access Latency - DMA and PIO 0000 98-99 Streaming Performance Granularity 0000 Seagate Laptop Thin HDD Product Manual, Rev. E...
- Page 30 0000 Transport major version number 101F 223–254 ATA-reserved 0000 Integrity word xxA5 See the bit descriptions below for words 63, 88 and 93 of the Identify Drive data. (on next page) Note Seagate Laptop Thin HDD Product Manual, Rev. E...
- Page 31 Ultra DMA mode 5 is currently active. Ultra DMA mode 6 is currently active. Word 93 1 = 80-conductor cable detected, CBLID above VIH 0 = 40-conductor cable detected, CBLID below VIL Seagate Laptop Thin HDD Product Manual, Rev. E...
-
Page 32: Set Features Command
Disable the Free Fall Protection feature (41 above enables the Free Fall Protection feature) Report full capacity available At power-on, or after a hardware or software reset, the Note default values of the features are as indicated above Seagate Laptop Thin HDD Product Manual, Rev. E... -
Page 33: Commands
S.M.A.R.T. Disable Operations S.M.A.R.T. Return Status If an appropriate code is not written to the Features Register, the Note command is aborted and 0x 04 (abort) is written to the Error register. Seagate Laptop Thin HDD Product Manual, Rev. E... - Page 34 Seagate Technology LLC 10200 South De Anza Boulevard, Cupertino, California 95014, United States, 408-658-1000 ASIA/PACIFIC Seagate Singapore International Headquarters Pte. Ltd. 7000 Ang Mo Kio Avenue 5, Singapore 569877, 65-6485-3888 EUROPE, MIDDLE EAST AND AFRICA Seagate Technology SAS 16-18 rue du Dôme, 92100 Boulogne-Billancourt, France, 33 1-4186 10 00 Publication Number: 100737930, Rev.
Need help?
Do you have a question about the ST500LM021 and is the answer not in the manual?
Questions and answers