Verification Stamp - Panasonic DP-C406 Operating Instructions Manual

Verification Stamp

This function confirms successful transmission or storage into the memory by stamping at the bottom
of each successfully transmitted original(s) with a small "x" mark.
The scanned document(s) are stamped after feeding through the ADF.
The standard setting of the Verification Stamp is "Off". The stamp setting can be changed with the Function
Parameter "04 Stamp (HOME)" (Fax/Email Settings > Fax Parameters). For instructions on how to change the
standard setting, refer to Fax/Email Settings in the Operating Instructions (For Function Parameters) of
provided CD-ROM.
The machine can be configured not to stamp the documents stored in the memory by changing the setting of
the Function Parameter "28 Stamp at Memory XMT" (Fax/Email Settings > Fax Parameters). For instructions
on how to configure the verification stamp, refer to Fax/Email Settings in the Operating Instructions (For
Function Parameters) of provided CD-ROM.
The Verification Stamp function is available when scanning documents with the ADF.
Because the verification stamp cannot be deleted, be careful not to use the verification stamp when
transmitting important document(s).
1
Place original(s) on the ADF.
Refer to Placing Originals (see page 14).
2
Press the Fax key.
40
Ex: Scanning Direction
Verification Stamp
3
Select "Basic Menu".