Download Print this page

Miratron The Prospector 7-295-000108 Operation Manual

Radio remote control 4-function rollback

Advertisement

Quick Links

Model: 7-295-000108, 4-function rollback
OPERATION
Using the remote control
Press the green button on the transmitter.
The LED will blink to indicate that the transmitter is on.
Press the keys to operate remote functions.
When finished, press the red button to turn OFF.
To conserve battery life, always turn off when not in use.
Transmitter will turn off automatically after 5 minutes of inactivity.
MAINTENENCE
General care
The transmitter features a protective rubber boot. However, it is best
to avoid dropping the transmitter as damage may result.
Take care with the belt clip. It will break if it is pulled too hard.
Cleaning of transmitter is recommended periodically, and may be
done with a clean, damp cloth. Submerging in water or pressure-
washing will damage the unit.
The receiver unit is encapsulated for protection, and has no service-
able parts inside.
Radio Remote Control

Operation Manual

Battery replacement
The transmitter is powered by a pair of "AAA" batteries. To replace
the batteries, follow these steps:
1. Remove transmitter from protective rubber boot.
2. Using a small phillips screwdriver, remove the screw.
3. Gently open the enclosure and locate the two batteries.
4. Using a small phillips screwdriver, remove the battery bracket.
5. Replace batteries and reassemble.
Be sure to insert batteries in the correct orientation as shown:
+
Transmitter replacement
In the event the transmitter is lost, stolen, or damaged. The receiver
must be programmed to the replacement transmitter. To program a
new transmitter, follow these steps:
1. Power the radio receiver (RF6) completely OFF then back ON
either by removing fuse, or Deutsch connector) to start a 10 second learn
window in the reciever.
2. During this 10 second window, press and momentarily (>1 sec.)
hold MIDDLE two buttons (both AIR green and red). Sending this
on of switches tells the still-learn-eligible receiver that this address is it's
intended party.
3. Immediately following these 2 steps the radio system should respond
normally
+

Advertisement

loading
Need help?

Need help?

Do you have a question about the The Prospector 7-295-000108 and is the answer not in the manual?

Questions and answers

Summary of Contents for Miratron The Prospector 7-295-000108

  • Page 1: Operation Manual

    Radio Remote Control Operation Manual Model: 7-295-000108, 4-function rollback Battery replacement The transmitter is powered by a pair of “AAA” batteries. To replace the batteries, follow these steps: 1. Remove transmitter from protective rubber boot. 2. Using a small phillips screwdriver, remove the screw. 3.
  • Page 2: Troubleshooting

    1. Out of range. Stand within 100 feet for best results. 2. Obstructions. Maintain line-of-sight to vehicle. 3. Interference. Make sure no other transmitters are operating in the immediate area. Other Consult factory. Miratron, Inc. 1-866-417-5008, Portland, Oregon www.miratron.com SPECIFICATIONS Transmitter Frequency 433MHz...