Miratron T–5 Operating Manual

T–5 Operating Guide
Photo for reference only. Actual product appearance will vary.
IMPORTANT!
Read this manual completely before operating system.
Keep this manual available for future reference.
Make sure the area is safe for operating equipment before
turning power on or starting equipment.
If you encounter any problem or malfunction, discontinue
use immediately, and contact your equipment dealer for
service or replacement parts.
CAUTION
Improper operation of these controls could cause damage
to equipment. Do not allow anyone to operate this
equipment before completely reading all manuals.
NOTICE
Miratron, Inc. controls are not intended for life or safety
applications. Miratron, Inc. shall not accept responsibility
for installation, application, or safety of machine or systems
which utilize miratron, Inc. controls.
MIRATRON 866-417-5008
Compact Keypad Remote Control
503-352-0654
Care and Handling
Failure to follow care and handling instructions will void the
warranty and could result in unsafe equipment operation.
Clean transmitter gently with a damp cloth or dry, compressed air.
Do not immerse transmitter in water, or spray with hose. Do not
store outside.
Do not drop transmitter or otherwise subject transmitter to
physical shock.
Do not expose transmitter to extreme temperatures.
Do not open transmitter enclosure. Transmitter contains no user
serviceable parts.
OPERATION
Controls
Transmitters are custom labeled, and may be equipped with a
"SHIFT" or "ALT" button to provide multiple functions for each
button. Take time to become familiar with the operation and
arrangement of the buttons before operating equipment.
Batteries
Th e T-5 transmitter operates from a standard 9-volt battery. Th e T-
5-SM transmitter operates from a pair of "AAA" batteries. Alkaline
batteries generally provide longest life. If rechargeable batteries are
used, NiMH type are recommended. T-5 Batteries are accessible
by a battery compartment door on the back of the transmitter. T-5
batteries are inside of the transmitter. A small phillips screwdriver
is needed to replace T-5-SM batteries. To ensure maximum battery
life, be sure to turn the transmitter OFF when not in use. Remove
batteries prior to shipping or storing transmitter.
Transmitter/Receiver Matching
Transmitters and receivers are shipped from the factory as matched
pairs. If a new transmitter is to be used, it must be trained to
operate the receiver.
Training procedure:
1. Power on transmitter and receiver.
2. Press "LEARN" button on receiver.
3. Operate transmitter normally.
www.miratron.com