Important Tips; After Every Use; Cleaning And Maintenance; Cleaning Procedures - Samsung Healthy Living CND-501S Instruction Manual

Compressor nebulizer
Table of Contents

Advertisement

Available languages

Available languages

2) Carefully attach the opposite end of the
air tube connector to the stem at the
base of the Nebulizer.
3) Attach the angled mouthpiece or mask
to the top of the Nebulizer.
If using an optional tee adapter set:
a) Attach the tee adaptor to the top of
the Nebulizer.
b) Connect one end of the tee adapter
to the straight mouthpiece and the
other to the extension tube.
Note: The tee adapter is not needed when using a mask.
4) Check that the POWER switch is in the "off" position. Plug the
power cord into a main outlet.
5) Press the POWER switch to the "on" position.
6) Start your treatment according to your
physician's or therapist's instructions.
Note: The crescent-shaped groove on the
side of the compressor can be used to sup-
port the nebulizer during treatments.
7) Once the treatment is complete, press the POWER switch to the
"off" position and unplug the power cord from the outlet.

IMPORTANT TIPS!

The Compressor will automatically shut off if it becomes overheated.
If/when this happens, immediately:
1) Press the POWER switch to the "off" position.
2) Unplug the power cord from the outlet.
3) Allow the motor to cool for 30 minutes.
Before restarting the unit, make sure that the air vents are not
obstructed.

After Every Use

1) Unplug the unit from the power source.
2) Allow the unit to completely cool.
3) Carefully detach the air tubing from the Nebulizer and pour out
any remaining medication.
4) Follow the cleaning procedures provided in this manual.
5
Operation of the Unit

Cleaning and Maintenance

Cleaning Procedures

Please consult with your physician or therapist prior to cleaning re-
garding the use of commercial disinfectants and appropriate cleaning
methods.
Cleaning Technique
(Performed after each treatment):
1) Make sure that the POWER switch has
been turned to the "off" position and
the unit has been disconnected from
the power source.
2) Disconnect the air tube from the base of
the Nebulizer.
3) Gently twist and pull up on the cover of
the Nebulizer to open and separate.
4) Wash all parts of the Nebulizer, the mouthpiece, and other op-
tional components in warm water with a mild detergent.
5) Rinse the Nebulizer and components with hot tap water.
6) Allow all parts to completely air dry on a clean paper towel.
Note: The air tube does not have to be washed as only filtered air
passes through it. Keep the outer surface of the air tube dust-free
by wiping regularly.
Disinfecting Technique
(Performed after the last treatment of the day or before first time use):
1) Follow steps 1-3 under "Cleaning Technique".
2) Submerge the Nebulizer parts in a clean container or bowl that con-
tains a vinegar/distilled water solution of one part white vinegar to
three parts distilled water. Let the parts soak for 30 minutes.
3) Follow steps 5-6 under "Cleaning Technique".
Nebulizer parts or reuse disinfecting solution as this could cause
contamination.
Note: For the Nebulizer only, clean in the dishwasher using the top
shelf. Do not place any Nebulizer parts in the dishwasher. Doing so
may cause damage.
Do not towel dry
6
Cleaning and Maintenance

Advertisement

Table of Contents
loading

Table of Contents