Factory Reset - ADT Network Camera User Manual

⑪
Panel: Connect the network, power and the external devices.
– NETWORK:
 Connect a Cat5 cable with an RJ-45 connector. You can change the settings, manage
the camera, upgrade the software or monitor video remotely via the network connection.
Refer to the INIT User's Manual for details about network connection setup.
 When using a PoE switch, the camera can be supplied with power over Ethernet cable.
Refer to the PoE switch manufacturer's manual for details.
 The network LED (green) indicates remote connection availability, and the network
link LED (yellow) indicates network connection status. See Appendix – LED Indicators
for details.
– DC12 (Power In): Connect two wires from the power adapter (12 VDC). You do not need
to distinguish power polarity when connecting the wires. The camera starts booting as
soon as power is applied.
– AU_O (Audio Out): Connect to an amplifier (Line-out). The camera does not have amplified
audio output, so you will need a speaker with an amplifier.
– AU_I (Audio In): Connect to an audio source (Line-in).
NOTES:

Camera and audio surveillance may be prohibited by laws that vary by region. Check
the laws in your area before using this product for surveillance purposes.

To make connections on the audio connector strip, press and hold the button and
insert the wire in the hole below the button. After releasing the button, tug gently on
the wire to make certain it is connected. To disconnect a wire, press and hold the
button above the wire and pull out the wire.
CAUTIONS:
 The camera restarts after the power adaptor is disconnected from the
camera when switching the power source from 12 VDC to PoE.
 The network connector is not designed to be connected directly with cable
or wire intended for outdoor use.
 Do NOT remove the SD memory card while the unit is operating; otherwise,
the system might not operate properly and recorded data saved on it might
be damaged.
WARNING: ROUTE POWER CORDS SO THAT THEY ARE NOT A TRIPPING
HAZARD. MAKE CERTAIN THE POWER CORD WILL NOT BE PINCHED OR
ABRADED BY FURNITURE. DO NOT INSTALL POWER CORDS UNDER RUGS
OR CARPET. THE POWER CORD HAS A GROUNDING PIN. IF YOUR POWER
OUTLET DOES NOT HAVE A GROUNDING PIN RECEPTACLE, DO NOT MODIFY
THE PLUG. DO NOT OVERLOAD THE CIRCUIT BY PLUGGING TOO MANY
DEVICES INTO ONE CIRCUIT.

Factory Reset

This switch will only be used on the rare occasions that you want to return all the settings
to the original factory settings.
Network Camera
5