Automation Setup For Jnior Devices - GDC SX-2000 Installation Manual

3.3.7 Automation setup for JNIOR devices

The SX-2000 server supports the JNIOR Model 310 automation device. Follow the steps below to
configure a JNIOR device in the server automation interface.
1. Click the [Add] button on the [Devices] tab and enter the name of the device. In this
case, it is "JNIOR". Set the device type to "JNIOR_IO" (see Figure 38).
2. Click [OK] and set up the device parameters for the JNIOR device.
3. Enter the IP address of the JNIOR device (see Figure 39).
4. The settings for 'Port', 'Login' and 'Password' are set to the default values for JNIOR
devices if left empty.
5. Click the [Save] button to save configured settings.
GDC Technology Ltd.
SX-2000 Installation Manual
Figure 38 JNIOR automation device setup
11/8/2010
Page 35 of 42