Automation Setup For Jnior Devices - GDC SX-3000 Installation Manual

14.7

Automation setup for JNIOR devices

The SX-3000 server supports the JNIOR Model 310 automation device. Follow the steps below to
configure a JNIOR device in the server automation interface.
1. Click the [Add] button on the [Devices] tab and enter the name of the device. In this
case, it is "JNIOR". Set the device type to "JNIOR_IO".
2. Click [OK] and set up the device parameters for the JNIOR device.
3. Enter the IP address of the JNIOR device (see Figure 57).
4. The settings for 'Port', 'Login' and 'Password' are set to the default values for JNIOR
devices if left empty.
5. Click the [Save] button to save configured settings.
SX-3000 Installation Manual
Figure 56 JNIOR automation device setup
Figure 57 Automation settings for JNIOR device
Page 36 of 43