Connecting Wires To Terminals - Kenwood KDC-BT742U Instruction Manual

Connecting Wires to Terminals

AUX input (Stereo)
Use the mini-plug cable which is stereo
type and does not have any resistance.
USB connector
Front side
Wiring harness
(Accessory1)
Power control wire (Blue/White)
Motor antenna control wire (Blue)
TEL mute wire (Brown)
Dimmer control wire (Orange / White)
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) · (To car chassis)
42
|
KDC-BT742U/ KDC-X493/ KDC-MP442U
Steering remote control
(Light Blue/Yellow)
REMO.CONT
To use the steering wheel
remote control feature, you
need to an exclusive remote
adapter (not supplied)
matches your car is required.
Fuse (10A)
White
White/Black To front left speaker
Gray
Gray/Black To front right speaker
Green
To rear left speaker
Green/Black
Purple
Purple/Black To rear right speaker
If no connections are made, do not let the wire come out from the tab.
When using the optional power amplifier, connect to its power control
terminal.
P.CONT
Depending on what antenna you are using, connect either to the control
terminal of the motor antenna, or to the power terminal for the booster
ANT.
CONT amplifier of the film-type or short pole type antenna.
Connect to the terminal that is grounded when either the telephone
rings or during conversation. (KDC-X493/MP442U only)
MUTE
⁄
To car light control switch
ILLUMI
Car fuse
box
ACC
To Kenwood disc changer/ External optional accessory
⁄
To connect these leads, refer to the relevant
instruction manuals.
To connect the Kenwood navigation system, consult your
navigation manual.
Ignition key
switch
Car fuse box
(Main fuse)
– + Battery
Rear output
R L
Front output
Sub Woofer output
FM/AM antenna input