Audio Setup; Speaker Setting - Kenwood KDC-BT742U Instruction Manual

Audio Setup

You can set Sound system , such as follows;
Adjustment Item Display
Front High Pass "HPF F"
Filter*  
Rear High Pass "HPF R"
 
Filter*
 
Low Pass Filter* "LPF SW"
 
Subwoofer Phase* "SW PHASE"
Volume offset "V-OFFSET"
Dual Zone System "2ZONE"
* Function of KDC-X493.
* Function of KDC-MP442U.
⁄
• Volume offset: Sets each source's volume as a difference
from the basic volume.
• Dual Zone System
Main source and sub source (Auxiliary input) output
Front channel and Rear channel separately.
- Set up the channel of sub source by "ZONE2" of
<Function Control> (page 6).
- Select Main source by [SRC] button.
- Adjust the volume of Front channel by [AUD] knob.
- Adjust the volume of Rear channel by <Audio Control>
(page 20) or [5]/[∞] button on the remote control
(page 34).
- The Audio Control has no effect on sub source.
1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Setup mode
Press the [AUD] knob for at least 1 second.
3
Select the Audio Setup item to adjust
Press the [AUD] knob.
4
Adjust the Audio setup item
Turn the [AUD] knob.
5
Exit Audio Setup mode
Press the [AUD] knob for at least 1 second.
Range
Through/40*  /60*  /80/100/
120/150/180/220*  Hz
 
Through/40* /60* /80/100/

120/150/180/220* Hz
 
50* /60/80/100* /120/
Through Hz
Reverse (180°)/ Normal (0°)
–8 — ±0 (AUX: -8— +8)
OFF/ON
Function of KDC-X493/MP442U

Speaker Setting

Fine-tuning so that the System Q value is optimal
when setting the speaker type as follows;
Speaker type
OFF
For 5 & 4 in. speaker
For 6 & 6x9 in. speaker
For the OEM speaker
1
Enter Standby
Press the [SRC] button.
Select the "STANDBY" display.
2
Enter Speaker Setting mode
Press the [AUD] knob.
3
Select the Speaker type
Turn the [AUD] knob.
4
Exit Speaker Setting mode
Press the [AUD] knob.
Display
"SP SEL OFF"
"SP SEL 5/4"
"SP SEL 6x9/6"
"SP SEL OEM"
|
English
21