Set Length 2 - Datalogic Touch 90 pro Product Reference Manual

References

Set Length 2

This feature specifies one of the bar code lengths for a given symbology. Length 2 is the
maximum label length if in Variable Length Mode, or the second fixed length if in Fixed Length
Mode.
Reference the
symbology being set. A setting of 00 specifies to ignore this length (only one fixed length).
Follow these instructions to set this feature:
1. Determine the desired character length. Pad the number with leading zeroes to yield two
2. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Programming
3. Scan the "Select Length 2 Setting" for the symbology being set.
4. Scan the appropriate two digits from the keypad in
NOTE
5. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming
This completes the procedure. See the table below for examples of how to set this feature.
Table 22. Length 2 Setting Examples
STEP ACTION
1 Desired Setting
2 Scan ENTER/EXIT PROGRAMMING MODE
3 Scan SELECT LENGTH 2 SETTING
Scan Two Characters From
4
Appendix D, Keypad
5 Scan ENTER/EXIT PROGRAMMING MODE
280
section to view the selectable range (number of characters) for the
Symbologies
digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
Mode.
length setting which was determined in the steps above. You will hear a two-beep indica-
tion after the last character.
If you make a mistake before the last character, scan the CANCEL bar code
to abort and not save the entry string. You can then start again at the
beginning.
Mode.
00 (ignore sec-
ond length)
'0' and '0'
Appendix D, Keypad
EXAMPLES
07 Characters 52 Characters
'0' and '7' '5' and '2'
Symbologies
, that represent the
74 Characters
'7' and '4'
Touch TD1100