Resetting Configuration To Defaults; Resetting The Product Configuration To Defaults - Datalogic Touch 90 pro Product Reference Manual

Setup

Resetting the Product Configuration to Defaults

If you aren't sure what programming options are in your reader, or you've changed some
options and want to restore the Custom Default Configuration that may have been saved in the
reader, scan the
configuration for the currently active interface.
NOTE
If you aren't sure what programming options are in your reader, or you've changed some
options and want to restore the Factory Configuration, you have two options. You can scan the
Restore USA Factory Configuration
Both labels restore the reader configuration to the factory settings including the interface type.
The USA label restores Label IDs to those historically used in the USA. The EU label restores
Label IDs to those historically used in Europe. The Label ID sets for USA and EU are shown in
the Label ID section of this manual.
CAUTION
The programming section on the following pages lists the factory default settings for each of the
menu commands (indicated by shaded blocks and bold text).
14
Restore Custom Default Configuration
Custom defaults are based on the interface type. Configure the reader for the
correct interface before scanning this label.
Restore Custom Default Configuration
bar code or the
Scanning either of the "Restore Factory Configuration" commands below will
result in the loss of any custom configuration settings for your device.
Restore USA Factory Configuration
Restore EU Factory Configuration
Customizing Configuration Settings
bar code below. This will restore the custom
Restore EU Factory Configuration
bar code below.
Touch TD1100