Philips Pocket Memo DPM8500 Configuration Manual page 28

Parameter # DFh
If you set ISBT Concatenation to Autodiscriminate, use this parameter to set the number of times the digital scanner
ISBT Concatenation Redundancy
must decode an ISBT symbol before determining that there is no additional symbol.
Parameter # DFh
Scan the bar code below, then scan two numeric bar codes in
If you set ISBT Concatenation to Autodiscriminate, use this parameter to set the number of times the digital scanner must decode an ISBT symbol
and 20. Enter a leading zero for single digit numbers. To correct an error or change a selection, scan
before determining that there is no additional symbol.
The default is 10.
Scan the bar code below, then scan two numeric bar codes in Numeric Bar Codes on page 56 to set a value between 2 and 20. Enter a leading zero
for single digit numbers. To correct an error or change a selection, scan Cancel on page 57. The default is 10.
28
Numeric Bar Codes on page 4-73
ISBT Concatenation Redundancy
to set a value between 2
Cancel on page 4-74.
Barcode scanner configuration guide