Table of Contents
Advertisement
Vision.net Touchscreens
Note: The external power supply must be mounted within 500 feet (150 meters) of the touchscreen. Two #14 AWG
conductors must be used.
Step 3. Connect power cable from 27VDC input connector on touchscreen to 3 pin connector on Touchscreen
Control PCB.
27VDC Power Input
To connect power supply (powering from Vision.net network):
WARNING! Make sure power is disconnected (removed) before connecting to touchscreen.
Step 4. As shown in Figure 5, at Touchscreen Control PCB make sure jumper - at JP1- is on Pins 1 and 2.
Touchscreen Control PCB
(located on back of touchscreen)
Wiring to Touchscreen
(factory wired)
Step 5. Connect SVN/485 network using Belden 1583A cable according to wiring diagram in Figure 6.
Figure 4: Touchscreen Power Connection
Figure 5: Touchscreen Control PCB Jumper Setting and Power Connections
Installation & User's Manual
Note:
Exploded view shown for clarity.
Touchscreen Control PCB
+27VDC Output
(to touchscreen - factory wired)
Power Cable
(Black with White Stripe)
Touchscreen
Vision.net LAN
Power Input
Detail A
Jumper
(across Pin 1 and 2)
Jumper JP1
(see Detail A)
Wiring and Connections
7
Hide quick links:
Advertisement
Table of Contents
