Trouble Shooting - CEL Power8 workshop User Manual

Trouble Shooting

Table Saw Won't switch on.
Difficult to install
parallel fence.
Difficult to remove
the fence.
Drill Press Won't switch on.
Check that the table saw shield is correctly assembled
to the bottom of the circular saw before assembling it
into the case.
Ensure that the internal power coupling is correctly
assembled onto the circular saw.
Check that the case lid and both latches are fully closed.
Ensure there is a CHARGED POWERhandle in the
charger dock.
Check that the green hook is fully under the ledge of the
lid before lowering the locking end of the post to the
work surface.
Check that the post is being assembled parallel with the
front or rear edge of the case; use the ruled scale to
check.
Before lowering the locking part of the post to the work
surface ensure the moving hook is open and can easily
move under the ledge on the charger dock.
To release the fence, Ensure that the sliding part of the
post is up and away from the case, then rotate the post
up around the green hook on the other end.
Ensure that the circular saw or jigsaw is not assembled
to the underside of the case lid.
Check that the drill head is fully assembled into the post
and the green locking latch is forward.
Ensure the post is assembled below the first locking
position.
15 15
10.3.1-4
10.3.7
10.3.8
10.3
10.3.9
10.3.9
10.3.9
10.3.9
11.4
11.4
11.4