Installing Software - ENCAD CADJET 3D Quick Start Manual

®
CADJET 3D Quick Start Guide

Installing software

Your printer comes with three software drivers and a software RIP:
•
ENCAD V/R Xpress RIP for general use
•
Heidi Driver - for printing files created with AutoCAD 2000
•
ADI Driver - for printing files created with versions of AutoCAD prior to
2000.
•
Windows 95/98/ME/NT4.0/2000 Driver - for printing files from Windows
applications other than AutoCAD.
All driver files are included on the System CD. The V/R Xpress RIP comes on
its own CD.
ENCAD V/R Xpress RIP
The ENCAD V/R Xpress RIP is a raster image processor (RIP) for printing
large, complex raster and vector images. Once installed, it can be seamlessly
integrated into the Windows environment, available from within any Windows
application or available as a standalone application to process PostScript, PDF
and HP-GL/2 files. It uses the power of the workstation to drive your printer at
maximum efficiency.
This RIP can be installed on any Windows 95/98/ME/NT4.0/2000 computer.
System Requirements
The ENCAD V/R Xpress RIP requires the following minimum configuration:
• Microsoft Windows NT version 4.0 with Service Pack 3, Windows 95/98/
ME/2000
•
Intel Pentium 166MHz (350MHz preferred), or compatible processor
•
64 MB of random access memory (RAM) minimum; 128 MB RAM recom-
mended
•
30 MB of available hard disk space for full installation
•
300 MB of available hard disk space (recommended) for temporary and
raster files, depending upon site configuration
•
200 MB of virtual memory (recommended).
•
CD ROM drive
•
VGA or better graphics
•
Mouse or other pointing device
38