Extinguishing The Stove Fully; Igniting The Permanent Pilot Light; Operating The Stove - Broseley Winchester Installation And Operation Manual

Page 12 of 20

OPERATING THE STOVE

It is important to read these instructions thoroughly before lighting the stove.
The gas stove operates with a traditional permanent pilot light.
The knobs for ignition and power control are located on the lower right hand side of
the stove.
The pilot light is located at the front middle of the coal matrix.
If the Flame Supervision Device Actuating Flame (the pilot light) is extinguished by
intention or not, no attempt should be made to re-light until 3 minutes have elapsed.

IGNITING THE PERMANENT PILOT LIGHT

1. Depress the rear control knob fully.
2. Whilst depressed, turn knob sharply 90 degrees anti-clockwise to "pilot" setting.
Repeat until pilot light is visibly lit. You should fell some resistance and hear a
click. Repeat until the pilot lights.
3. Keep knob depressed at this point for 15-20 seconds.
4. Upon releasing, turn the knob anti-clockwise until it stops in the permanent pilot
light position. The permanent pilot light will remain lit. This is the position for
remote operation and can be left with the pilot running. You may wish to turn off
the stove during long periods of non-use perhaps during the summer months.
SEE SEPARATE INSTRUCTIONS FOR RUNNING THE STOVE UNDER REMOTE
CONTROL.
In the event of a failure of the remote control, the front control valve can be adjusted
manually by rotating between the high and low positions.

EXTINGUISHING THE STOVE FULLY

1. From any heat setting or the permanent pilot, depress the rear control knob and
turn clockwise to "OFF" position.
Should the glass door become broken or damaged in any way, turn your stove off and do
not attempt to re-light it. Contact your dealer for a replacement to be fitted before
relighting the appliance.
PLEASE EXPLAIN TO THE CUSTOMER THESE LIGHTING AND
EXTINGUSIHING PROCEDURES AND THAT IT IS NORMAL FOR THE
STOVE TO GIVE OFF ODOURS WHILST THE PAINT, SEALANT AND CAST
IRON MATURES.