Continuous Mode; Test Mode; Laser Mode - CipherLab 1166 User Manual

1166/1266 Barcode Scanner

1.5.1 CONTINUOUS MODE

The scanner is always scanning.
After a successful decoding, the removal of barcode is required. It is not allowed to
proceed to decode until the preset decoding delay time has passed.
To decode the same barcode repeatedly, move away the barcode and put it back
again and again for scanning.
Note: Refer to "Delay between Re-read".

1.5.2 TEST MODE

The scanner is always scanning.
Capable of decoding the same barcode repeatedly without removing it, for testing
purpose.

1.5.3 LASER MODE

The scanner will start scanning once the trigger is held down.
The scanning won't stop until (1) a barcode is decoded, (2) the pre-set timeout
expires, or (3) you release the trigger.
Note: Refer to "Scanning Timeout".
Note: By default, the scan mode is set to Laser mode.
28
User Guide
Continuous Mode
Test Mode
*Laser Mode
Enter Setup