Recording; B.e.s.t. Picture System - JVC HR-P110AG Instructions Manual

Recording

Recording
Use the following procedure to record TV
programmes on a blank video tape.
Before proceeding:
To record TV programmes, the video
cassette player must be connected to the
TV as shown in connection B of the
"Connections" on page 6 section.
Turn on the power of the TV and video
cassette player.
Make sure that the video cassette's safety
tab is intact. If it has been removed, cover
the hole with adhesive tape.
1
COLOUR SP/LP
SYSTEM /EP
2
3
2
A
Load a blank video tape.
B
Press SP/LP/EP (p) to set the
recording speed.
C
Press to start recording. (On the
7
remote control unit press
at the same time.)
The recording indicator will light
during recording.
POWER-ON STANDBY/REC
3
3
and
7
B.E.S.T. takes place at the beginning of
each first SP and first LP (or EP) recording
after inserting the cassette.
Press ¤ on the video cassette player
8
on the remote control press 8 to stop
recording.
To stop recording temporarily:
Press
8
The recording indicator will blink.
Press
$
NOTES:
To engage recording standby, press 7 and
then press
indicator will blink during recording
standby. Press
If 7 does not work, check to see if the
cassette safety tab has been removed.
The player automatically stops when
record-standby continues for more than 5
minutes.
The video tape will be rewound
automatically when the end of the tape is
reached.

B.E.S.T. picture system

The B.E.S.T. (Biconditional Equalized Signal
Tracking) system checks the condition of the
tape in use during recording and playback,
and compensates to provide the highest
possible recording and playback pictures.
The default setting for both recording and
playback is ''ON''.
Recording
The video cassette player assesses the quality
of the tape once you initiate recording.
The player spends approximately 7
8
seconds assessing the condition of the
tape, then begins recording.
$
.
9
to resume recording.
. The STANDBY/REC
9
again to start recording.
$
13