Chevrolet 1967 Chevelle Service Manual page 509

CHASSIS SHEET METAL 11-22
wiring harness, and washer bottle from radiator
support.
5. Remove screw connecting battery tray to radiator
support.
6. Remove shroud from vehicle if so equipped.
7. Remove shroud and radiator (Section 13).
8. Remove screws securing support to frame, skirts,
and fenders.
9. Remove radiator support from vehicle.
Installation
Install radiator support following the removal pro-
cedure in reverse order. Refer to torque specifications
in rear of manual for correct torque values for radiator
supportj grille, and bumper.
FENDER AND SKIRT ASSEMBLY
Removal
1. Remove front bumper (Section 14).
2. Remove hood and hood.hinges (two men).
3. Remove bolts securing brace to skirt and dash panel
and remove brace (fig. 32).
4. Disconnect any components attached to fender and
skirt such as cruise control, hoses, electrical har-
ness etc.
5. Remove screws securing radiator support to fender
and skirt.
6. Remove headlamp bezel and headlamp.
7. Remove screws securing fender and skirt assembly
to header panel, headlamp housing and valance panel.
Remove screw securing fender extension to valance
panel.
8. Remove screws securing fender and skirt assembly
to vehicle and remove fender and skirt assembly.
9. If necessary, remove screws attaching fender ex-
tension and bumper bracket to fender and remove
extension and bracket. Replace fender trim if nec-
essary.
Installation
Install fender anci skirt assembly following the removal
procedure in reverse order. Refer to torque specifi-
cations in rear of manual for correct torque values.
HOOD ASSEMBLY
Procedures for hood removal and installation for
Camaro are the same as for Chevrolet and Chevelle.
Refer to Chevrolet and Chevelle hood removal and in-
stallation procedures, Figure 35 for Camaro hood catch,
support, and lock plate, and Figure 37 for Camaro hood
and insulator.
HOOD CATCH AND LOCK (Fig. 35)
Removal
1. Remove catch plate assembly by removing screws
retaining catch to header panel, center support, and
radiator support.
NOTE: Before removing hood lock plate from
hood, locate position on hood by scribing around
base of lock plate.
2. Remove lock plate by removing screws retaining lock
plate to hood and remove lock plate.
Fig. 35 - Hood Catch, Support, and Lock Plate - Camaro
Installation
Install lock and catch plate following the removal pro-
cedure in reverse order. Refer to torque specifications
in rear of manual for correct torque values. Adjust lock
and catch plate as outlined under adjustment procedure
in this section.
HOOD TRIM AND INSULATION (Fig. 37}
. Figure 37 shows the installation details of the Camaro
hood ornament and insulation pad. The insulation and
ornament retainers and nuts are accessible from under
the raised hood.
COWL VENT GRILLE
.Procedures'for Camaro cowl vent grille replacement
are the same as for Chevrolet and Chevelle. Refer to
Chevrolet and Chevelle cowl vent grille replacement.
CHEVROLET CHASSIS SERVICE MANUAL