Turret Rotation Locking Pin - Dieci Pegasus Operator's Manual

Model E.T. PEGASUS

TURRET ROTATION LOCKING PIN

(fig.39/C)
The turret rotation locking pin is used to block the turret
when it is aligned with the lower chassis. The pin is located
on the right side of the machine (fig.39/C Pos "1").
- CAUTION:
When the pin is not in use, it must be stored in its housing
(fig.39/C Pos."2").
- CAUTION:
During road use the turret must be locked.
To insert the rotating lock:
- Place any loads on the ground.
- Completely retract and lower the telescopic boom.
- Align the turret with the lower chassis. The pilot light
in the instrument cluster (fig.41/C Pos "A") will indicate
whether the operation has been carried out correctly.
- Engage the parking brake.
- Switch off the machine and remove the ignition key.
- Get out of the cab and insert the locking pin in its hou-
sing (fig.39/C Pos."3").
- The locking pin is correctly positioned when it passes
through the housing on the upper chassis (fig.40/C
Pos."1") and is inserted in the housing on the lower
chassis (fig.40/C Pos."2"). The pilot light in the instru-
ment cluster (fig.41/C Pos."B") will indicate that the pin
has been inserted.
- If the pin does not enter correctly, place the pin in its
housing (fig.40/C Pos."1"), get back in the cab and turn
the turret (using very small movements) until the pin falls
into the housing (fig.40/C Pos."2").
- CAUTION -
Do not attempt to rotate the machine when
the locking device is inserted.
C/30
(fig.40/C)
(fig.41/C)
- CAUTION:
- Read the SAFETY REGULATIONS (in this manual) carefully for the safety of all personnel and the machine.
Getting to know and using the machine
2
3
(fig.39/C)
A
1
1
2
B