Table of Contents
Advertisement
FM tuner (IHF)
Usable Sensitivity:
50 dB Quieting Sensitivity:
Signal-to-Noise Ratio (IHF-A weighted):
Total Harmonic Distortion:
Stereo Separation at REC OUT:
Alternate Channel Selectivity:
Frequency Response:
AM tuner
Usable Sensitivity:
Signal-to-Noise Ratio
General
Power Requirements:
Power Consumption:
Dimensions (W x H x D):
50
Tuning Range:
87.5 MHz to 108.0 MHz
Monaural:
Monaural:
Stereo:
Monaural:
Stereo:
Monaural:
Stereo:
35 dB at 1 kHz
45 dB: (±400 kHz)
30 Hz to 15 kHz: (+0.5 dB, –3 dB)
Tuning Range:
530 kHz to 1,710 kHz
Loop antenna
AC 120V , 60 Hz
320 watts/420 VA (at operation)
2 watts (in standby mode)
435 mm x 157 mm x 412.5 mm
3
(17
/
in. x 6
16
Mass:
11.9 kg (26.3 lbs)
Designs & specifications are subject to change without notice.
12.8 dBf (1.2 µV/75 )
21.3 dBf (3.2 µV/75 )
41.3 dBf (31.5 µV/75 )
78 dB at 85 dBf
73 dB at 85 dBf
0.4% at 1 kHz
0.6% at 1 kHz
400 µV/m
50 dB (100 mV/m)
3
1
/
in. x 16
/
in.)
16
4
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the RX-7000VBK and is the answer not in the manual?
Questions and answers
mi amplificador no activa el reley de audio
The JVC RX-7000VBK amplifier may not be activating the audio relay due to the following possible causes:
1. Power Cord Not Plugged In – Ensure the power cord is properly connected to an AC outlet.
2. Speaker Signal Cables Not Connected – Check and reconnect speaker wiring if necessary.
3. Speakers 1 and 2 Buttons Not Set Correctly – Press the SPEAKERS 1 and 2 buttons properly.
4. Incorrect Source Selected – Ensure the correct audio source is chosen.
5. Muting Is Activated – Cancel muting by pressing the MUTING button.
6. Balance Set to One Extreme – Adjust the balance settings.
7. Weak FM Signal (For FM Reception Issues) – Try connecting an outdoor FM antenna or selecting a different station.
If none of these solutions work, further troubleshooting or service from a JVC service center may be required.
This answer is automatically generated
Could I plug a tablet in to one of the outputs to used for music
The JVC RX-7000VBK has audio input terminals, including composite audio (red and white RCA) and potentially other connections. If the tablet has a headphone jack or supports an audio output adapter, it can be connected to the receiver using a 3.5mm to RCA cable. This would allow music playback from the tablet through the receiver.
This answer is automatically generated
@Mr. Anderson thank you for the information if you could tell me there's two locations to plug in a subwoofer now I have a powered subwoofer how would I go about plugging that in properly