Adjustment Of Receiver; Matters Needing Attention - Walkera Master cp User Handbook Manual

Flybarless series
Hide thumbs Also See for Master cp:
Table of Contents

Advertisement

6.5 Adjustment of receiver

(1) Status of LED indicator of receiver: quick flash means the signal is being received; solid lighting means the
signal has been received; slow flash means no signal has been received.
(2) Gyro
turning
knob: CW rotating towards (+) increases the gyro sensitivity and CCW rotating towards (-)
decreases the gyro sensitivity.
(3) Servo extent knob: CW rotating towards (+) increases the servo travel and CCW rotating towards (-)
decreases the travel.
(4) Receiver fixed ID cancellation: Insert the supplied BIND PLUG into the ELEV channel in the receiver, and
then power on the receiver. The red light of receiver will flash slowly. This means the fixed ID code has
been cancelled. Remove the BIND PLUG.
(5) Receiver upgrade:
(5.1) Master CP control program upgrade can be downloaded online at Walkera Offical Website:www.walkera.com.
(5.2) Master CP control program upgrade tool including UP02 cable and UP02 Adapter.
(5.3) Connect blue single wire plug to ELEV signal position, yellow single wire plug connect to AILE signal
position; black single wire plug connect to AILE position of earth wire.

6.6 Matters needing attention

(1) All the signal wires should be connected in the correct way. Misconnection will result in failure to receive
signal and even damage the receiver.
(2) Use the special adjustment pen supplied to rotate the servo extent dial and gyro sensitivity dial in order to
avoid damaging the adjustment dials.
(3) The helicopter must be placed in horizontal level when matching code.
(4) Please strictly follow the sequence of "power on the transmitter first, then connect the battery". Turn on the
transmitter, then connect the battery with receiver within 10 seconds, the red light on receiver begins flash. The red
light will get a solid light 1-3 seconds, after the transmitter finishes pairing with receiver, the red light will flash
again. If the red light get a solid light and a mechanical BEEP sound can be heard from the servo, it means the
receiver have received the signal from the transmitter and their codes match successfully.
10
UP02 Adapter
Yellow single wire
Blue single wire
UP02 Adapter
Black single wire
UP02
UP02
06
Setup of the
RX2637H-D
receiver

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Master cp and is the answer not in the manual?

Questions and answers

Table of Contents

Save PDF