Table of Contents
Advertisement
4. Fuel Injection System
Fault Code and Sensors Table
Fault
No.
codes
1
0120
2
0105
3
0115
4
0195
5
0110
6
1630
7
0130
8
0201
9
0351
10
0230
11
0135
12
1505
13
1410
Exhaust 2
14
0335
15
1205
16
0603
4-42
To this chapter contents
Fault Description
Throttle position sensor fault
Manifold absolute pressure sensor fault
Engine temperature sensor fault (water)
Engine oil temperature sensor fault (oil)
Intake air temperature sensor fault
Roll over sensor fault
O
sensor fault
2
ＩＮＪ #1 fault
IG #1 fault
Fuel pump fault
O
sensor heater fault
2
ISC Idle speed control motor fault
nd
air control solenoid valve fault
Crankshaft position sensor fault
MAP wire fault
EEPROM fault
Parts Inspection
TP Sensor and wire
MAP sensor and wire
TW Sensor and wire
Engine temperature sensor and wire
TA Sensor and wire
Roll over sensor and wire
O
Sensor and wire
2
Injector and wire
Ignition coil and wire
Fuel pump and wire
O
Sensor and wire
2
ISC stepper motor and wire
AISV and wire
Crankshaft position sensor and wire
sensor and wire
MAP
EEPROM
- Quick Links:
- Service Manual
- Engine Oil/Strainer Clean
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
Need help?
Do you have a question about the MAXSYM 400i and is the answer not in the manual?
Questions and answers
как заменить охлаждающую жидкость?
To replace the coolant in a Sym MAXSYM 400i, follow these steps:
1. Open the radiator cap.
2. Remove the hose from the engine and drain out the coolant.
3. Pump in high-pressure air from the water hole to vent out remaining coolant from the pipe.
4. Reinstall the hose and any removed parts.
5. Refill with the specified coolant as necessary.
6. Check for any leakage after refilling.
Caution: Ensure the engine is completely cooled before working on the cooling system to avoid burns.
This answer is automatically generated