E804-0004 Error Code Displaying If The Jack Of The Controller Fan (Fm7 Which Is Fixed On The Controller Box; E804-0004 Due To Faulty Fuse Pcb Error Code; E805 Error Code Detail The Cleaner Fan Is Faulty - Canon iR C3200 Series Service Manual

Chapter 16
16.3.10.130 E804-0004 Error code Displaying if the jack of the controller fan
(FM7) which is fixed on the controller box
Symptom
Don't know where to install the jack of the controller fan (FM7) that is installed onto the controller box cover.
If the fan jack is not inserted, E804-000 is displayed.
Cause
The controller fan (FM7) cable should be inserted into J1512 on the distribution board PCB at the bottom of the
controller box, but the position can't be seen because of the cables inside the machine.
Field Remedy
Insert the controller fan (FM7) cable into J1512 on the distribution board PCB.

16.3.10.131 E804-0004 due to faulty fuse PCB Error Code

Symptom
E804-0004 due to faulty fuse PCB Error Code
Description
E804-0004 is displayed when a halt of the controller fan (FM7) is detected.
Cause
As a result of inspection, the fuse PCB was found to be faulty (FU12 was burnt.).
Field Remedy
There is a snap-tight connector of the controller fan (FM7) at the rear cover of the main controller. Check the
connection.
- If the connection is poor, reinsert the connector.
- If there is no problem in the connection, it is possible that the fuse (FU12) has been burnt. So, check whether
it is burnt or not. If it seems to be burnt, replace the fuse PCB with a new one.

16.3.10.132 E805 Error code detail The cleaner fan is faulty.

Symptom
E805 The cleaner fan is faulty. (Error code detail)
Description
Detail
0001
16-182
T-16-68
Description
The DC controller tried to start it, but the fan has been
identified as being at rest for 5 sec continuously.
Timing of detection
0002-2937
0002-8536
0002-1841