Emt Tool - Specialized 2014 FSR Owner's Manual

The EMT Tool can be mounted two ways:
Directly to a Specialized Zee-Cage 2, with the Cage-Mount Tool cradle
1
Install the metal bracket into the Cage-Mount Tool cradle (the round hole goes into the cradle, the oblong hole aligns with the Zee-Cage's lower
frame mounting hole).
Align the hole at the base of the Zee-Cage 2 over the hole in the Cage-Mount Tool cradle.
Insert the T-Nut into the Frame Tool cradle from below.
Thread the T-Bolt into the T-Nut. Torque the T-Bolt to 15 in-lbf (1.7 Nm).
Install the EMT tool into the cradle.
NOTE: The EMT Tool with Cage-Mount Tool cradle and Zee-Xage 2 can be installed on many bike models. Some frames are not compatible due to
interference between the frame and the Cage-Mount Tool cradle. Verify that the fit is unobstructed before installation.
Directly into the Frame Tool cradle above the upper shock eye (2014 Epic Carbon frames only)
1
Insert the tool into the cradle from an angle. As the tool slides into position, press the tool upward, making sure the tool's external pivot bolts are
above the small retainer bumps (fig.2-A). Ensure that the tool clicks into place at the back, to hold it in snugly.
Press up on the tool as it slides into the cradle until the tool clicks into place.
To remove the tool, apply upward pressure with a finger or two and pull the tool toward the head tube.
Page 6 of 20
CAGE-MOUNT
TOOL CRADLE
FRAME TOOL CRADLE

EMT TOOL

2
2
A