Angle Setup - Pioneer PDP-425CMX Technical Manual

Tilt Mount Unit: PDK-5011

4.6.4 Angle setup

This installation hardware allows the display to be tilted down freely at any angle from the vertical to 25°.
This adjustment must always be done by 2 people.
Adjust the angle by rotating the screws at the center top and center bottom of the wall side hardware (left or right).
Notes
• It is difficult turn the center-bottom screw while increasing the angle. When this happens, adjust the angle by turning
the top-center screw.
• Turn the screws very carefully to avoid damaging the wall.
• When a screw becomes tight at either end of the adjustment range, do not turn the adjustment screw any. Doing so
applies excessive force, deforming the screw.
A Criterion for the vertical location
Gap
disappears
Wall side hardware
When it is in this state, do not turn
the adjustment screw any further in
the closing direction.
Opening
Closing
A
Resin plate
68
Back of the
Plasma Display
Resin plate
Hexagon wrench
B
Angle of incline and appearance of the screw for angle
adjustment from a horizontal position on the front
Standard hole
16° or more
B Criterion when its angle is 25°
End face of the plate
Matched in both
directions
Notch
When it is in this state, do not turn the
adjustment screw any further in the
opening direction.
Measuring the opening distance X provides
an approximate angle value.
Tilt Angle Criteria
Angle X
5° 194 (7-5/8)
10° 243 (9-1/2)
15° 290 (11-3/8)
20° 336 (13-1/4)
25° 379 (14-7/8)
Unit: mm (inch)
Upper hole
visible 23° or more visible
X