Mounting The Unit; Unit Startup; Programming Options; Normal Programming - Danfoss FP735Si Installation Manual

3.4 Mount the unit on the wallplate
GB GB
3.5 With the unit powered up, it is recommended to press and
release the RESET button to start up the FP735Si unit.

4.0 Programming Options

FP735Si is delivered with a set of parameters that have been pre-
programmed to cover the most typical type of installations. See
(5.0). If a diff erent parameter setup is wanted the unit provides two
programming options:
4.1

Normal programming

Normal Programming is meant for setting the timing profi le that
controls the ON and OFF periods for the room heating and for the hot
water. A daily profi le may be programmed and a profi le can control
the entire week where the weekend may be handled separately. Also a
timing profi le for a holiday can be entered.
As part of the normal daily operations, a simple one-button press
(+HRS) can extend a running ON period for room heating and/or hot
water by one hour. This can be repeated 3 times giving up to 3 hours
extension.
6
Note: Always switch
the mains off fi rst
and never fi t/remove
the timer to/from a
live wallplate.
FP735SI