Originals And Paper - Toshiba e-studio2050c Troubleshooting Manual

8 WHEN SOMETHING IS WRONG WITH THE EQUIPMENT

Originals and paper

Problem Description
The original is misfed.
Paper is misfed.
Two or more sheets of
paper are fed together.
Sheets are not aligned
when exiting.
126 When You Think Something Is Wrong With the Equipment
Cause
The original is unsuited for the
equipment.
The paper is unsuited for the
equipment.
The paper size setting
registered for the equipment
is inconsistent with paper in a
drawer or on the bypass tray.
The stack of paper exceeds
the loading line indicated on
the side guide.
There is too little or too much
clearance between the paper
and the side guide of the
drawer.
Hidden misfed paper has not
been removed.
Sheets of paper are stuck
together.
Sheets are not placed in the
drawer with correct side up for
this equipment.
The type of paper
corresponding to that being
used has not been set.
Corrective Action
Check whether the original is suitable for the
equipment.
For details, refer to Chapter 2 of the Copying
Guide.
Check whether the paper is suitable for the
equipment.
For details, refer to Chapter 1 of the Copying
Guide.
Match the size of the paper placed in the
drawer or on the bypass tray and the size
registered on the equipment.
For details, refer to Chapter 1 and 2 of the
Copying Guide.
Remove some paper to set it within the height
limit line indicated on the side guide. In
particular, be sure that the upper limit for thick
paper is not exceeded when placing thick
paper in the first drawer. The amount of thick
paper you can load in the drawer is lower than
that for plain paper.
Adjust the space between the paper and the
side guide or the end guide not to take much
space.
For details, refer to Chapter 1 of the Copying
Guide.
Check the sign again on the touch panel to
see where the misfeed occurred.
P.15 "Clearing a Paper Misfeed"
Loosen the stack of paper well and set it
again.
Check the printing side of the sheets and
place them correctly. Information about the
printing side may be given on the wrapping
paper of the sheets.
If you cannot find which side is the printing
side, try printing on both sides to see if the
sheets are aligned when exiting.
Check that the set paper type corresponds to
the paper in use.
For details, refer to Chapter 1 of the Copying
Guide.