Removing The Floppy Drive - Mitsubishi Electric LS Pro Hardware Technical Reference

3. Hinge the system board metalwork to the vertical as shown below:
4. Disconnect the loudspeaker cable from the system board.
5. If your system is fitted with a floppy disk drive disconnect the ribbon cable at the
system board taking care not to strain the cable or its connectors.
6. Lift the system board metalwork clear of the computer.
7. Invert the system board metalwork, and rest it on a flat surface.
8. Replacement is simply the reverse of removal. Take care to ensure that the
metalwork engages correctly. Do not use undue force. Route the loudspeaker
cable between the front of the system unit and the LEDs.
Removing the The floppy drive is mounted in the metalwork above the system board.
floppy drive
Two variants of metalwork have been used, they are both shown in the illustration
below.
System unit
LS PRO HARDWARE TECHNICAL REFERENCE 2/7