GB 48
4.
4.3
Dismantling the drive (Figure 4-3, 4-5 and 4-6)
Preparation
Remove the housing cover as described in section 1.
Remove the front panel as described in section 3.
–
Undo the two screws (B) of the stay and pull it up to
remove it.
–
Push back lift by 5 cm after releasing both lift stops.
–
Undo and remove the four fastening screws (C) of the
drive.
–
Undo and remove the ground screw (D) at the rear.
–
(For this purpose, insert the screwdriver through the hole
in the back panel).
–
Remove the cables from the drive.
–
Bend back the guard of the scanner cable.
–
Remove the scanner cable from the socket.
–
Return the lift into the "Eject" position.
–
Slightly lift the left rear side of the drive to undo the
connector to the capstan motor.
–
Press both catches (S) together with fine pliers and lift
the drive around the snapholders.
–
The drive may be separated from the motherboard.
Assembly
Assemble in reverse order.
Important
Observe that the cables (K1; K2; K3) are positioned in the
supports on the rear of the frame and that the ground screw
(D) is screwed in!
Service position
VR120
Dismantling instructions
C
C
D
Figure 4-6
D
D
C
C
S
S
C
C
C
C
S S
Figure 4-5