Cub Cadet GT 2544 Operator's Manual page 22

NOTE: We do not recommend the use of a pressure
washer or garden hose to clean your tractor. They may
cause damage to electrical components; spindles;
pulleys; bearings; or the engine. The use of water will
result in shortened life and reduce serviceability.
5. Lubricate all lubrication points shown on page 26.
6. Follow the battery storage instructions on page 20.
7. Protect the tires and seat from sunlight. Regularly
check the tires to maintain proper inflation.
ADJUSTMENTS
ADJUSTING THE SEAT
WARNING: Do not adjust the seat when
the tractor is moving. Adjusting the seat
while the tractor is moving could cause
the operator to lose control of the tractor.
Both seat arm rests can be rotated upward for mount-
ing and dismounting the tractor, or for the personal
comfort of the operator.
Before starting the tractor, adjust the seat forward or
rearward to the most comfortable driving position. To
reposition the seat, move the seat adjustment lever
(See Figure 5-3) toward the left and slide the seat
forward or rearward. Release the adjustment lever
when the seat is comfortably positioned. Gently rock
the seat forward or rearward to be sure the seat is
locked in place.
Figure 5-3
Move Lever
to Left
SEAT
ADJUSTMENT
LEVER
ADJUSTING LIFT ASSIST SPRING TENSION
The effort required to operate the implement lift handle
can be varied by loosening or tightening the lift assist
spring adjusting bolts on each side of the tractor (See
Figure 5-4). The bolts can be accessed from the rear of
the tractor, inside the left and right rear wheels. Turning
each adjusting bolt clockwise will decrease the manual
effort required for
counterclockwise will increase the effort needed to lift
the attachment. It is recommended that both lift assist
springs be adjusted to approximately the same tension.
DECK LEVELING ADJUSTMENTS
In order to achieve even cutting, the mower deck must
be properly leveled. This leveling procedure will result
in the left and right blades having corresponding front
cutting-edge-to ground measurements within 1/16 inch
of each other. Also, the blades will each have a 1/8 to
1/4 inch downward tilt toward the front of the tractor. To
level the mower deck, proceed as follows:
WARNING: Before making any adjust-
ments, place the PTO switch in the "OFF"
position, engage the parking brake, turn
the ignition key to the "OFF" position and
remove the key from the switch. Discon-
nect the spark plug wires for additional
safety. When handling the mower deck,
be careful not to cut yourself on the
sharp blades.
22
lifting attachments;
LEFT LIFT
ASSIST SPRING
ADJUSTING
BOLT
Figure 5-4
turning