Ucd Busy Mode - Panasonic KX-TA308 Installation Manual

[523]-[524]

[523] UCD Busy Mode*

Selects the operation when the length of time programmed in [521] "UCD Busy Waiting
Time" expires. Intercept or Disconnect is available.
Intercept: The call will be redirected depending on programs [408]-[410] "Flexible
Disconnect: The call will be disconnected immediately.
5
Default
• The above-mentioned intercept is only occurs when "MODE 3" or "MODE 5" is selected
!
!
in program [502] "OGM Mode Selection". If "MODE 4" is selected, the call will be
disconnected after the UCD-END outgoing message. If "MODE 6" is selected and
"Intercept" is assigned in this program, the call will be led to the DISA feature by OGM2.
• Feature References
Section 3, Features
Intercept Routing, Uniform Call Distribution (UCD)
[524] UCD Intercept Mode*
Selects the operation when all extensions in the UCD group do not answer an outside call
via the UCD feature within the length of time programmed in [525] "UCD Ringing Time
before Intercept". Intercept or Disconnect is available.
Intercept: The call is redirected depending on programs [408]-[410] "Flexible Ringing
Disconnect: The call is disconnected.
5
Default
• Feature References
Section 3, Features
Intercept Routing, Uniform Call Distribution (UCD)
4-68
System Programming
1
Ringing Assignment–Day/Night/Lunch" (Intercept Routing feature). The
extension which receives a redirected call rings during the length of time
programmed in [526] "UCD Ringing Time after Intercept".
2 3
NEXT
Intercept
1
Assignment–Day/Night/Lunch" (Intercept Routing – No Answer feature).
4
2
NEXT
Intercept
4.2
SELECT
STORE
(Intercept/
Disconnect)
SELECT
STORE
(Intercept/
Disconnect)
* 1 : Required only when the optional OGM/FAX Detection
Card is installed.
System Programming
END
END