NEC Univerge SV8100 Features And Specifications Manual page 801

UNIVERGE SV8100
Program
Program Name
Number
44-05-01 ARS/F-Route Table – Trunk
Group Number
44-05-09 ARS/F-Route Table – Maximum
Digit
84-06-01 PVA Data Setting – RTP Port
Number
84-06-02 PVA Data Setting – RTCP Port
Number
84-06-04 PVA Data Setting – Fract Lost
Threshold
84-06-05 PVA Data Setting – Packets Lost
Threshold
84-06-07 PVA Data Setting – Jitter
Threshold
84-06-09 PVA Data Setting – Delay LSR
Threshold
84-06-16 VoIP Info – IMCP Redirect
84-10-01 ToS Setup – ToS Mode
84-10-02 ToS Setup – Priority, IP
Precedence
IP Trunk – (SIP) Session Initiation Protocol
Description/Comments
Assign the trunk group to be used
by the ARS/F-Route Table.
Input the maximum number of
digits to send when using the
F-Route.
Define the Media Gateway starting
RTP Port Number.
Define the Media Gateway
Starting RTCP Port Number . The
RTCP Port Number must be the
(RTP port number + 1).
Define the fractional lost threshold
– this data will be sent to the
UNIVERGE SV8100 CD-CP00-US
when the value exceeds the
defined value.
Define the packet lost threshold –
this data will be sent to the
UNIVERGE SV8100 CD-CP00-US
when the value exceeds the
defined value.
Define the Jitter Threshold – this
data is sent to the UNIVERGE
SV8100 CD-CP00-US when the
value exceeds the defined value.
Define the Delay threshold – this
data will be sent to the UNIVERGE
SV8100 CD-CP00-US when the
value exceeds the defined value.
Set whether or not IPLA daughter
board supports sending the
Internet Message Control Protocol
(IMCP) redirect message.
When Input Data is set to 1,
Protocol 7 is invalid. When Data is
set to 2, Protocols 2~6 are invalid.
1 = Router queuing priority.
Assigned Data
1
0~100, 255
0 = No Setting
255 = Extension Call
(default = 0)
0~24
(default = 0)
0~65535
(default = 10020)
RTP Port Number + 1
(default = 10021)
0~100%
(default = 0)
0~16777215
(default = 0)
0~4294967295
(seconds)
(default = 0)
0~4294967295
(seconds)
(default = 0)
0=No
1=Yes
(default = 0)
0 = Disable (Invalid)
1 = IP Precedence

2 = Diffserv
(default = 0)
0~7
0 = Low

7 = High
(default = 0)
Issue 8.01
Level
2 3









2 - 773