Default Settings - NEC Univerge SV8100 Features And Specifications Manual

Hide thumbs Also See for Univerge SV8100:

Table of Contents

UNIVERGE SV8100

If a user enters a code that exceeds 16 digits, the system ignores the Account Code Entry.

If the system has Account Codes disabled, the digits dialed (e.g.,

SMDR report as part of the number dialed.

If using Forced Account Code with single line telephone you need a VRS to get the prompts

to enter the Forced Account Code.

When you use Forced Account Code on only toll calls, and you dial a local call, you hear a

The timer set in Program 21-01-14 is applied to toll calls and local calls.

Speed Dial – System/Group/Station bins can contain stored Account Codes. They can be

prevented from being displayed using Program 20-07-04.

To simplify Account Code Entry, store the Account Code (e.g.,

Key. Just press the key instead of dialing the codes.

Account Codes appear on the SMDR report (even if they are hidden on the telephone

Do not use an asterisk in a PBX/CTX access code when using Account Codes. The

causes the trunk to stop sending digits to the central office until another

Account Codes for incoming calls are not available for single line telephones.

When using Forced Account Codes (Unverified) for toll calls only, the station follows the

timer setting in Program 21-01-14 for all calls.

System Account codes are bypassed when using DISA trunks. If a user calls in via a DISA

trunk, the user is not required to enter an account code.

When Account Codes are enabled in a Class of Service, extensions in that Class of Service

no longer follow the Maximum Dialing Digit setting in the ARS/F-Routes.

Verified Account Codes for Toll Calls across a CCIS network are not restricted when a trunk

access code is added to the number allowing ARS routing through another K-CCIS T1/IP

networked site. This access code (typically a 9), precedes the dialed "1" used by the

system to identify a long distance call. As a result, the call is no longer considered long

distance and the account code is not required.

Default Settings

Account Code – Forced/Verified/Unverified

) appear on the

) in a One-Touch

Table of Contents