NEC Univerge SV8100 Features And Specifications Manual page 231

UNIVERGE SV8100
Trunk-to-Trunk Forwarding – DID (3) Trunk Forwarding by Department Groups:
 Refer to Departmental Calling for additional Department Group programming.
Program
Program Name
Number
11-07-01 Department Group Pilot
Numbers – Dial
11-11-25 Service Code Setup (for Setup/
Entry Operation) – Automatic
Transfer Setup for Each
Extension Group
11-11-26 Service Code Setup (for Setup/
Entry Operation) – Automatic
Transfer Cancellation for Each
Extension Group
11-11-27 Service Code Setup (for Setup/
Entry Operation) – Destination of
Automatic Transfer Each
Extension Group
13-01-01 Speed Dialing Function Setup –
Speed Dialing Auto Outgoing
Call Mode
13-04-01 Speed Dialing Number and Name
– Speed Dialing Data
14-01-04 Basic Trunk Data Setup –
Transmit Gain Level for
Conference and Transfer Calls
14-01-05 Basic Trunk Data Setup –
Receive Gain Level for
Conference and Transfer Calls
Call Forwarding, Off-Premise
Description/Comments
Assign pilot numbers to the
Extension (Department) Groups
you set up in Program 16-02.
Customize the service code to be
used to set the Automatic Trunk
Forwarding feature for a
Department Group.
Customize the service code to be
used to cancel the Automatic
Trunk Forwarding feature for a
Department Group.
Customize the service code to be
used to set the destination for the
Automatic Trunk Forwarding
feature for a Department Group.
Determine if dialing an Speed
Dialing number will dial an outside
number (seizing a trunk as
assigned in Program 13-05) or an
Intercom number (0 = Trunk
Dialing Mode, 1 = Extension
Dialing Mode).
Enter the Common and Group
Speed Dialing numbers and
names which are to be used for
Trunk-to-Trunk Forwarding.
CODEC gain set at 0 dB [Program
14-01-04 = 32 (CODEC Gain Type
2)] can be used to set the transmit
CODEC gain type for multiline
Conference or transferred calls.
CODEC gain set at 0 dB [Program
14-01-04 = 32 (CODEC Gain Type
2)] can be used to set the transmit
CODEC gain type for multiline
Conference or transferred calls.
Assigned Data
1
Up to eight digits

(default not assigned)
MLT, SLT
(default = 602)
MLT, SLT
(default = 603)
MLT
(default = 604)
0 = Trunk Outgoing
Mode
1 = Intercom Outgoing

Mode
(default = 0)
#
1~9, 0, ,
Pause (Press line key
1)
Recall/Flash (Press
line key 2)

@ = Code to wait for
answer supervision in
ISDN (Press line key 3)
(maximum 24 digits)
(default not assigned)
1~63(-15.5dB ~
+15.5dB in 0.5dB
intervals)
[default = 32 (0dB)]
1~63(-15.5dB ~
+15.5dB in 0.5dB
intervals)
[default = 16 (-8dB)]
Issue 11.0
Level
2 3





2 - 199