Shelves; Temperature Control - GE 14 Use And Installation Manual

TEMPERATURE CONTROL DIAL
The temperature control dial has nine settings plus
"OFF". "1" is the warmest. "9" is the coldest. At
first, set the dial at "5." After using the refrigerator,
adjust the dial if necessary.
Insert a coin into the slot in the middle of the dial and
you can turn the dial to the setting that's best suited to
your needs.
Allow 24 hours for the refrigerator to get cold.
NOTE: Turning the dial to "OFF" stops cooling in
both compartments—fresh food and freezer.
FRESH FOOD COMPARTMENT SHELVES
Half-Width Shelves
One end of the shelf
2
rests on a molded
Lift up
side-wall support; a
and out
bracket on the other
end hooks into a
track on the rear
cabinet wall.
To remove, lift the
shelf up at front, then
off the support and
out of the track.
To replace, select desired shelf height. With shelf
front raised slightly, hook the bracket's top lug into
the track, then lower the shelf onto the support.
Full-Width Shelves
Some models have a steel wire sliding shelf, a
stationary tempered glass shelf or two steel wire
stationary shelves. These shelves can be moved to
another place in the fresh food compartment.
The full-width sliding shelf has
stop-locks. When placed
correctly on the shelf supports,
the shelf will stop before
coming completely out of the
refrigerator and will not tilt
when you place food on it or
remove food from it.
4
Shelf supports at various levels allow you to custom-space shelves.
(on some models)
1
Tilt up
(on some models)
5
NOTE: The shelf to the right of
the track is designed to hook into
the right-hand slot; the shelf to the
left is designed to hook into the left-
hand slot.
To remove the
full-width shelves.
Lift the rear of the
shelf and pull
forward.
To remove a full-
width shelf when
the fresh food
compartment
door cannot be
opened fully...
lift the rear of the
shelf, pull forward
and down, tilt the
shelf and take it out.